Setup Instructions: Pro IDPA Competition Rig

The rig comes assembled with the holster and mag pouches matched to your pistol. Size the belt first (see "Belt sizing"), then set up the gear.

1. Size the belt. Measure twice, cut once, following the Belt sizing steps.
2. Set the attachments to your belt. The holster and both mag pouches use the same clip. Press the two buttons on each side to open it. Pull off the two plastic tabs inside and press them back on in the position that fits your belt (the Tactical Gun Belt is 1.5'').
3. Lock the attachment screws. Put a drop of removable (medium strength) thread locker on the screws that hold the belt attachment to the holster and to each mag pouch, so they stay tight. Don't use a permanent thread locker, because it can seize the screws.
4. Clip on the gear. Close each clip over the belt until it locks. Put the holster on your right hip and the two mag pouches on the side opposite your holster. Check the current IDPA rulebook for holster and pouch placement before a match.
5. Set the retention. With an unloaded pistol and empty magazines, turn the Phillips retention screws on the holster and on each pouch. Tighter holds more securely while you move. Looser lets the pistol or magazine come out with less effort.
6. Check it. Make sure every clip is closed and locked, and recheck the screws before each match.

Tools

• 2mm Allen key: belt buckle screws (included)
• Phillips screwdriver: holster and pouch retention screws (not included)
• Removable (medium strength) thread locker (not included)