QUESTION: How can I make this holster work with a 2'' belt?
The Pro IDPA Holster's belt attachment has two smalls tabs that can be removed to accommodate a 2'' belt.
QUESTION: Why can't I adjust the ride height of the holster?
The ride height on this holster is designed to meet IDPA rules. We hate to limit the angle/height adjustments of our holsters but this is unfortunately the case for these models.
QUESTION: How tight can this holster get?
The retention on this holster can be adjusted to the point that you will not be able to draw the gun from the holster but we will obviously never recommend that.
QUESTION: Is this holster compatible with my red dot sight?
The way the holster is designed and cut will allow you to use any red dot sight.
QUESTION: Will this holster work with suppressor height sights?
Yes (mostly). The holster's sight line is raised by 15mm which will allow for most suppressor height sights to pass through.
QUESTION: Can I use a threaded barrel with this holster?
Yes, the holster is designed to allow threaded barrels to pass through.
Black Scorpion Gear proudly supports our Military, Law Enforcement Officers, and First Responders. We are thankful for your service and contributions which is why we offer a standing policy to provide a discount to all of our Military Service Men and Women, as well as to our Law Enforcement Officers, Firefighters, and First Responders. The process is simple. Verify your eligibility below and we'll provide you with a discount code instantly.
Law Enforcement Discount, First Responders Discount, LEO Discount
Fantastic holster for competing. Easy to draw from and stays firm and upright with my tac belt on. My gun is rather heavy so I am impressed that it doesnt cant outwards more.
The sides don’t line up, there are sharp edges and mine has a large sliver of kydex I had to cut off, screws walk out about every 10 draws and need loctite, and the whole holster is pretty flimsy (but I’ll give it that one bc of the design). The molding doesn’t fit around the slide properly, it pinches along the top edges. This causes inconsistent draws and gets the gun stuck about 20% of the time unless you very mindfully holster while pressing the gun back in the holster toward the trigger guard. If you do that then you get a consistent draw. I was going to return it and even had an RMA until I figured out that trick to keep it from getting stuck. Ultimately I’m keeping it because it’s inexpensive and for a competition only gun, and I found the trick to get it to work most of the time.
Got the carbon fiber for my P320 AX with a Sig Pro optic. Easy to use and adjust. Very straightforward but still good quality.
Very cool holster. I bought it for the AXG Scorpion and it fits great. Planning on using it as a backup Carry Optics gun for IDPA. I went with the carbon fiber. Looks great.
I was looking for my 1st holster that fit my gun and sights. I had a hard time finding one. The few I found were not of high quality and wasn't sure if it would fit my gun as configured. With this holster I had no doubt it would work for my gun - the only question was how would the quality be. After receiving it not only fit my gun but was of high quality. I'm sure I will be able to get many years of use from this holster.